Fig 2 - uploaded by Hemlal Bhattarai
Content may be subject to copyright.
Download
View publication
represents waveform of simulation without fault or non-linear load. Without fault or non-linear load, waveform obtained is pure sinusoidal. A 0.2 second simulation time is set to run the simulation. The waveform obtained are in the sequence of power, current and voltage.

represents waveform of simulation without fault or non-linear load. Without fault or non-linear load, waveform obtained is pure sinusoidal. A 0.2 second simulation time is set to run the simulation. The waveform obtained are in the sequence of power, current and voltage.

Source publication
Fig. 2 represents waveform of simulation without fault or non-linear...
Fig.3. Simulink model of single phase non-linear load with Harmonic Filter
Fig.7 shows the 33 kV feeder with non-linear load with DSTATCOM....
Fig.11. Total Harmonic Distortion in R phase due to L-G fault
+2 Fig .6. Reduced total harmonic distortion
Harmonic Distortion Analysis of MV Substation
Conference Paper
Full-text available
  • Dec 2018
Harmonic disturbances are one of the disturbances in power system which affects power quality [1]. This paper presents the amount of harmonics presents in 132/33 kV substation. The modeling of 132/33 kV substation is carried out in Matlab/Simulink environment. The waveform obtained is analyzed by Fast Fourier Theorem which gives the total harmonic...
Cite
Download full-text

Similar publications

PQ issues and rectification⁶ (Published under open access).
Harmonic current flowing because of a non-linear load.
STPF configuration.
A flow chart demonstrating the methodology flow.
+5 (a) Current signal aberration, (b) THDI\documentclass[12pt]{minimal}...
Single-tuned passive filter (STPF) for mitigating harmonics in a 3-phase power system
Article
Full-text available
  • Nov 2023
Numerous integrals of the fundamental frequency are known as harmonics and can be found in power systems or electrical circuitry systems. Non-linear loads occasionally drain current or contains a varying impedance with each period of the AC voltage are often responsible for power system harmonics. This can result in system overheating, system losse...
View
Power Measurement Results
IHDi Measurement Results
Second Order High Pass Filter Simulation Results
Simulation Results of C-Type Filter
+1 Simulation Results of Filter Combinations
Design and Simulation High Pass Filter Second Order and C-Type Filter for Reducing Harmonics as Power Quality Repair Effort in the Automotive Industry
Article
Full-text available
  • Mar 2023
Electrical distribution is one of the most important parameters in industrial processes. Therefore, good power quality is needed as a supply to industrial machines. The use of industrial machines has an impact on the emergence of harmonics. As a result of the large Harmonics, the quality of power is getting worse, affecting productivity in the indu...
View
Fig. 1: Power system one-line diagram [11][16]
Fig. 2: Sag voltages under LG fault at D-yg connection
Fig. 4: The Matlab/Simulink model for the classification of voltage sag...
Fig. 5: Sag voltages under LL fault at D-yg connection
+2 Fig. 7: Sag voltages under LLG fault at D-yg connection
A Comparative Study of the Voltage Sag Propagation under Un-Symmetrical Faults through Distribution Transformer on Low Voltage Power Network
Article
Full-text available
  • Jun 2021
In this paper, the characterization of the voltage sag propagation under unsymmetrical faults through distribution transformer for low voltage power network is tested with the help of a power analyzer, which is based on sequence components. The voltage sag is a big issue of the power quality (PQ) for the power system networks, which must be analyze...
View