Figure 7 - uploaded by Emre Özlü
Content may be subject to copyright.
Source publication
In this study, the application of chatter stability diagrams in industrial operations is presented with representative cases. Challenges arising due to the practical aspects of production systems are discussed in detail. Effects of tool, tool holder, spindle and CNC machine on chatter stability diagrams are presented. The implementation of the stab...
Contexts in source publication
Context 1
... when the spindle is changed a new stability diagram should be calculated in order to select the best cutting parameters. In Figure 7 comparisons of two stability diagrams calculated before (old spindle) and after (new spindle) the change of a spindle can be seen. As can be observed from Figure 7 some favorable areas became unstable regions after the change which resulted in higher absolute stability limit and wider stability pockets. ...
Context 2
... Figure 7 comparisons of two stability diagrams calculated before (old spindle) and after (new spindle) the change of a spindle can be seen. As can be observed from Figure 7 some favorable areas became unstable regions after the change which resulted in higher absolute stability limit and wider stability pockets. Thus, it can be deduced once again that, conditions which are very close to the stability boundaries should not be selected since even slight variations in the dynamics may shift the stable cutting regains. ...
Similar publications
The development of high performance machining processes is a key aspect to achieve higher productivity, efficiency and performance in modern production systems. In order to reduce the corresponding effort and costs, simulation systems are one possibility to support the design and the optimization of manufacturing processes. In this article, three d...
