Figure 3 - uploaded by Ronald Mcdowell
Content may be subject to copyright.
Schematic diagram of the Helderberg Seaway showing possible connections to open ocean (modified from Smosna, 1988, his figure 3, p. 267; reprinted by permission of the Canadian Society of Petroleum Geologists).

Schematic diagram of the Helderberg Seaway showing possible connections to open ocean (modified from Smosna, 1988, his figure 3, p. 267; reprinted by permission of the Canadian Society of Petroleum Geologists).

Source publication
Article
Full-text available
The Midwest Regional Carbon Sequestration Partnership recog-nizes that both the Devonian Oriskany Sandstone and the Silurian Salina Group offer potential for subsurface carbon dioxide storage in northern West Virginia. The Silurian–Devonian Helderberg Group lies stratigraphically between these two units, and consequently, its potential as a geologi...

Contexts in source publication

Context 1
... were possibly present on all four sides, but it is not clear if all of these led to open ocean. At least one major con- nection to open ocean must have existed during early deposition of the Helderberg, however, to allow for adequate influx of nutrients during deposition of this normal marine limestone (Smosna, 1988) (Figure 3). ...
Context 2
... resulted in thickening toward the basin cen- ter that was associated with extensive normal faulting throughout the entire basin. Although the eastern flank of the Rome Trough is well defined by dramatic breaks Schematic diagram of the Helderberg Seaway show- ing possible connections to open ocean (modified from Smosna , 1988, his figure 3, p. 267; reprinted by permission of the Canadian Society of Petroleum Geologists). ...

Similar publications

Article
Full-text available
The capacity for fault systems to be reactivated by fluid injection is well-known. In the context of CO2 sequestration, however, the consequence of reactivated faults with respect to leakage and monitoring is poorly understood. Using multi-phase fluid flow simulations, this study addresses key questions concerning the likelihood of ruptures, the ti...
Article
Full-text available
[1] Important to large-scale implementation of Carbon Capture and Sequestration is the ability to monitor the carbon dioxide (CO2) that has been injected underground. The focus of this study is to understand how flow processes during CO2 injection impact the pressure observed at a nearby monitoring well. In particular, we are interested in how the...
Article
Full-text available
Background: While the capability of forests to sequester carbon dioxide (CO2) is acknowledged as an important component in fighting climate change, a closer look reveals the difficulties in determining the actual contribution by forest management when indirect and natural impacts are to be factored out. The goal of this study is to determine the d...
Article
Full-text available
A basin-scale model of geologic carbon sequestration (GCS) in the basal sandstone of the Illinois Basin is being developed. This generation of the GCS model includes a new temperature profile, new brine salinity data, a new injection wellfield design, and revised geologic data. Modeling results indicate that 100 million tonnes of CO2 per year for 5...
Article
Full-text available
The complex physics of multiphase flow in porous media are usually modeled at the field scale using Darcy-type formulations. The key descriptors of such models are the relative permeabilities to each of the flowing phases. It is well known that, whenever the fluid saturations undergo a cyclic process, relative permeabilities display hysteresis effe...

Citations

... Simon Sandstone, the Galway Sandstone) present interesting opportunities for larger-scale geothermal reservoirs if the right combination of depth and temperature coincide (US DOE 2012;Slater et al., 2008). Other options include potential saline aquifers, unmineable coal beds, and depleted oil and gas reservoirs, which have been geologically characterized for carbon sequestration (e.g., Carr et al., 2009;Kostelnik and Carter, 2009;Lewis et al., 2009;Tamulonis et al. 2012;2014;Jordan et al., 2012). ...
Conference Paper
Full-text available
Given that a large portion of the United States' primary energy consumption goes into heating, cooling, and providing electricity to residential and commercial buildings, geothermal energy has significant potential to deliver and distribute both thermal and electrical energy on a community scale. Excluding a few exceptional cases in the U.S., the focus for development has been on producing electricity from high-grade hydrothermal systems located in various western U.S. states. By ignoring the potential to deliver thermal energy directly, a large portion of the U.S. geothermal resource is marginalized. In particular, lower grade, lower temperature hydrothermal and Enhanced Geothermal Systems (EGS) resources are more widespread and have sufficient temperatures (> 80ºC) that they are ideally suited for direct-use applications. By employing Geothermal District Heating (GDH) on a community scale, low grade hydrothermal and EGS in formations with poor permeability have the potential to supply a significant fraction of the thermal energy (temperatures < 125ºC) throughout the U.S., used for heating buildings, supplying hot water, and for lower temperature process heating. A key objective of our study is to characterize a number of important geothermal resource types ranging from conduction-dominated EGS to permeable sedimentary aquifers, as well as technical and economic factors that influence the levelized cost of delivering geothermal heat and/or electric power to a range of communities in the Eastern U.S. from lower grade resources (temperatures < 125ºC). To demonstrate the level of deployment possible, we developed a regional model to evaluate the potential for GDH in the states of New York and Pennsylvania. A GDH network was simulated at each population center within the study region and the levelized cost of heat (LCOH) was estimated from GDH for each community. LCOHs were then compiled into a supply curve from which several conclusions were drawn. Our evaluation revealed that geothermal resources have the potential to supply cost-effective energy for space and water heating in several New York and Pennsylvania communities in the near future. To realize wider deployment in NY, anticipated increases in conventional fuel prices, and/or more aggressive renewable energy policies and incentives along with modest improvements in EGS technology are needed to enable GDH to compete with other heating alternatives. In addition, creative implementation strategies would also help overcome the cost barriers that exist today for geothermal by focusing initially on developing the infrastructure needed for district heating and combined heat and power systems at a community scale. These district energy systems could be designed to initially utilize conventional fuels and waste biomass feedstocks and later transition to using geothermal energy as their primary energy source.
Conference Paper
Full-text available
Previous studies (DCNR &MRCSP) have suggested that Pennsylvania may contain lithologic and structural features that are possible traps for carbon sequestration. The purpose of this study is to determine if gravity data, used in conjunction with other geophysical information, can be used to effectively model subsurface variations to determine the potential for carbon sequestration in Indiana county. While borehole and seismic data have been used to create a structure map in Indiana County, these data are limited to a portion of the county. However, extensive gravity data exists across the state of Pennsylvania. The existing structure maps can be correlated with the gravity anomalies. There is a strong spatial correlation between the long wavelength negative gravity anomalies and the structural lows identified from the other geophysical data. There is also a strong spatial correlation between long wavelength positive anomalies and structural highs. Subsurface density models are created that are constrained by the gravity anomalies, structure surfaces, bed thickness, and formation density. The models are used to make estimates on the potential volume available for sequestration. The potential is summarized using subsurface structure maps, cross-sections and volume estimates.It is predicted that Indiana County has the potential to store 1.31*1011 tons of carbon, which is enough space to store the carbon captured from two local power plants for 55 years.