Fig 2 - uploaded by Duggirala Venkata Naga Ananth
Content may be subject to copyright.
Pin diagram of ARDUINO. The board has 14 Digital pins and 6 Analog pins. It is programmable with the Embedded C.
Source publication
The main objective of this project is to provide uninterrupted power supply to a load, by selecting the supply from any source out of 4 different sources such as mains, generator, and inverter and solar automatically in the absence of any of the source. As we know that the demand for electricity is increasing every day and frequent power cuts is ca...
Similar publications
Irregular power supply poses a serious problem in many developing countries with power outage usually experienced on a regular basis. Thus, this challenge necessitates the need for an automated method of power change over to an alternative source during power failure that will be an improvement over the manual change over system. This study aims to...
Photovoltaic power generation is the most significant way to utilize solar energy in the world today. Facing the severe fossil energy crisis and environmental crisis facing the world today, photovoltaic power generation has obvious advantages from the perspective of resource sustainability and environmental friendliness. The access of distributed p...
The use of a circuit breaker in the power system cannot be over emphasized. When fault is detected in a power system, the power system is disconnected form the power supply due to the presence of the circuit breaker which prevents the fault from damaging the power system. In this design, a simple and reliable programmable solid-state circuit breake...
In this paper, an experimental system based on Arduino Uno microcontroller board was developed for measuring electrical quantities and protecting overvoltage and undervoltage conditions in a single-phase power supply. The main components are described in detail, including the hardware and software to build the system in which an Arduino Uno platfor...
In order to solve the problems existing in the traditional relay protection methods, such as poor relay safety and large fault location error of distribution network, this paper proposes a multilevel differential relay protection method based on feeder segment switch. The configuration principle and the selection principle of multilevel range are d...
Citations
... This action can be done when the relay driver receives a signal from the microcontroller, and consequently, the relay drive switches on the appropriate load relay. The same switching control technique mentioned previously in Ref. [7] has been followed by Dayana [8] and Ananth et al. [9]. They found that the presented auto control power supply system is reliable, effective, and efficient. ...
... Global Journal of Energy Technology Research Updates,9, 2022 ...
The energy consumption by residential air conditioners could cost about half of the total energy consumption of the building. A combination of conventional and renewable energy is still an emerging technology. Therefore, using solar photovoltaic panels to provide electricity to the air conditioner is a substantial application. This research shows the possibility of using photovoltaic panels as a power source for air conditioners in a sequence exchange with the conventional grid. A smart switching system has been offered to organize the power supply between the grid and solar panels. The photovoltaic panels have been connected to the conditioner across a power inverter module for adopting a reliable and accurate quantity of power supply to the conditioner unit. The smart switching system provides an intelligent connection between the solar power source and the grid, ensuring an uninterrupted electricity supply between the two power sources.
In this project represents the real time monitoring of a distribution transformation based on iot, i.e. Implemented on a mobile embedded system to measure to load current, voltage, temperature and humidity. The internet of things is an online based working of physical devices, vehicles and other objects which consists of an embedded system with sensors, actuators and network connectivity that collect and exchange data. The iot allows the objects to be sensed and/or controlled remotely across the existing network of the physical world into computer-based systems, and result in improved accuracy, efficiency and economic benefits. It is installed at the distribution transformer site. The load current, voltage, temperature and humidity of the distribution transformer is measured by the sensors are processed and recorded in the system memory. The system is programmed with a code to check the abnormal condition. The iot will help the utilities to monitor the distribution transformer in minute to minute date transfer to the user to identify the problems before any catastrophicfailure occurs. Hence the minute to minute monitoring of a distribution transformer health measuring will help us to identify or predict the unexpected situations before any fault occurs which leads to a greater economic loss.
