Figure 4 - uploaded by Mohammed Lahsaini
Content may be subject to copyright.
Download
View publication
Normalized fringing capacitance for an isolated rectangular bar [13]

Normalized fringing capacitance for an isolated rectangular bar [13]

Source publication
Figure 1. Compact planar structure
Figure 2. A combline, band pass filter [2]
Figure 3. Normalized even-mode fringing capacitance í µí° ¶ í µí±“í...
Figure 4. Normalized fringing capacitance for an isolated rectangular...
+2 Figure 5. Structure of the third-resonator combline filter
Performance Analysis of Low noise amplifier using Combline Bandpass Filter for X Band Applications
Article
Full-text available
  • Sep 2019
This paper describes a procedure for designing broadband low noise amplifier for X-Band applications. The design and implementation are based on HEMT transistors AFP02N2-00 of Alpha Industries®. The matching circuit used for modeling the microwave amplifier is the quarter-wave transformers impedance matching technique associated to combline bandpas...
Cite
Download full-text

Similar publications

Fig. 13: Single-stage cascode S-parameter simulation utilizing either...
Fig. 15: Measured vs. simulated S-parameters of the 128-µm TGW PA, WR-2.2.
Fig. 16: Measured vs. simulated output power over the operating BW of...
Fig. 17: Measured vs. simulated output power over the operating BW of...
+5 Fig. 18: Re-simulated output power of the first doubler and buffer MPA...
Broadband 400-GHz InGaAs mHEMT transmitter and receiver S-MMICs
Article
Full-text available
  • Jul 2021
The modeling, design and experimental evaluation of both a 400-GHz transmitter and receiver submillimeter-wave monolithic integrated circuit (S-MMIC) is presented in this paper. These S-MMICs are intended for a radar-based system in the aforementioned operating frequency. The transmitter occupies a total chip area of 750 ×2750 μm2. It consists of a...
View