Figure 8 - available via license: Creative Commons Attribution 3.0 Unported
Content may be subject to copyright.
Download
View publication
Model of 3D dies (a. the tapered die of dig angle 30? C; b. streamlined die).

Model of 3D dies (a. the tapered die of dig angle 30? C; b. streamlined die).

Source publication
Table 1 . The comparison and contrast of three types of FEM
Figure 2. Stress-strain curves at 300? C at different strain rates [11].
Figure 3. The simulated load-displacement curves under different...
Figure 4. The simulated load-displacement curves under different...
+1 Figure 8. Model of 3D dies (a. the tapered die of dig angle 30? C; b....
Research Progress of the Simulation on the Hot Extrusion of the Magnesium Alloys
Article
Full-text available
  • Aug 2018
Simulation technology is one of the important means in the extrusion process of metal. This paper reviewed the recent the simulation studies on the hot extrusion of magnesium alloys: at first, the constitutive equations of several commonly used in Mg alloy were presented; afterwards, simulation on forming processes of Mg alloy were analyzed, and th...
Cite
Download full-text

Similar publications

The misorientation angle histograms. aλ = 44.44. bλ = 19.75. cλ =...
a and b The schematic diagrams of the SE process. c–e Schematic...
Photograph of the bending products by the SE process
Schematic diagram of bending radii of bending products
+3 The grain morphology maps and grain size histograms. aλ = 44.44. bλ =...
Effect of extrusion ratio (λ) on dynamic recrystallization of AZ31 magnesium alloy bending products prepared by staggered extrusion (SE)
Article
Full-text available
  • May 2020
Traditional bending products are usually divided into two steps: extrusion and bending. Staggered extrusion (SE) as a new process was proposed to prepare Mg alloy bending products in this paper. By designing the structure at one end of the stem, the dual functions of extrusion process and bending process can be realized in a single extrusion pass....
View