Table 3
Contexts in source publication
Context 1
... characteristic fusion temperatures of the ashes of raw fuels and their mixture, which were determined by the heating microscope, are represented in Table 3. These temperatures are important for predicting the slagging and fouling tendencies of the fuels in boilers and are directly related to ash chemistry and mineralogy. ...
Context 2
... was confirmed by the present experiments conducted in the fluid bed configuration, where no signs of ash deposition or bed agglomeration were noticed. Nevertheless, Table 3 shows that the fluid temperatures of both ashes exceeded 1500 °C. However, the very small temperature difference between the ST and FT of vine wood ash (41 °C) implies a higher fouling rate inside the boilers. ...
Similar publications
It is known that the use of alternative fuels leads to changes in the operating parameters of internal combustion engines, and the nature of the changes in most cases is not known. Therefore, the question of researching the main operating indicators of the internal combustion engine supplied with RME B100 biodiesel fuel is important, and the result...
High pressure humidified cycles can combine high operational flexibility and high thermal efficiency. The current work introduces such a cycle, namely TopCycle, which provides the necessary combustion infrastructure to operate on a wide fuel variety in a steam-rich atmosphere. The cycle configuration is presented in detail, and its operation is exe...
The popularity of electrified transportation is rising at a sharp pace due to environmental concerns over internal combustion (IC) engines. Researchers are nowadays looking for a brushless and permanent magnet (PM)-less solution for electric vehicle (EV) motors. Wound-field synchronous motor (WFSM) is a potential solution for EVs and is being used...
![The chemical specifications of test fuels [3,45].](publication/372328806/figure/tbl2/AS:11431281174511313@1689255752343/The-chemical-specifications-of-test-fuels-3-45_Q320.jpg)
Recently, studies have been carried out using environmentally sustainable technologies with more efficient energy conversion to fulfill emission requirements. One of these technologies, reactivity controlled compression ignition (RCCI), is a low-temperature combustion mode and has a dual fuel strategy. The controllability of combustion, high therma...
Citations
... Biomass-to-energy conversion leads to green energy, which is important from an environmental point of view, as well as the management of the crop waste. (Alves et al., 2020;Greinert et al., 2019;Vamvuka, 2019). As a matter of principle, residues from wine production can be managed by combustion (Florindo et al., 2022;Mencarelli et al., 2022), anaerobic digestion (Da Ros et al., 2016;Hidalgo et al., 2023), or pyrolysis (Dunnigan et al., 2018;Manyà et al., 2021). ...
