Fig 5 - uploaded by Wisam Abu Jadayil
Content may be subject to copyright.
Source publication
Realizing the nature of the manufacturing process used to make a part can help determine the locations and the optimum number of inspection points. Face and End milling processes are used in this work to produce plates and sheets. A Finite Element Analysis (FEA) model has been developed for cutting of flat plates. That model helps minimizing the nu...
Similar publications
The response of direct metal laser sintering (DMLS) produced Ti6Al4V (ELI) to impact was investigated using an instrumented Charpy impact test machine and V-notch specimens. Impact toughness testing was conducted over the temperature range of-130oC to 250oC. The effect of the orientation of the V-notch, with reference to the base plate, was investi...
Citations
The main factors of car accidents were statistically investigated in Jordan. The car accidents were classified into three major categories, collisions, rollover and run over accidents. As the human errors were found to be the major reason for all kinds of accidents, they were classified into thirteen types of errors. The most serious errors of drivers causing accidents were failing to take correct measurements during driving, tailgating and incorrect lane taking. As the percentage of female drivers is less than 25%, they were found to make more collisions than male drivers, but male drivers make more run over and rollover accidents. Young male drivers were found to make more accidents than old ones. But young female drivers made less accidents than middle age and old female drivers. Statistical significance analysis showed that driver errors are the major factors of accidents in general, and collisions and turn over accidents in specific.
