Figure - available via license: Creative Commons Attribution 3.0 Unported
Content may be subject to copyright.
Source publication
The micro structural and mechanical activity of resistance spot welds (RSW) conducted on 6063-T6 aluminium alloy sheets and SS 304 stainless steel welded at various welding parameters is investigated in this report. In order to determine the effect of welding parameters on the efficiency of the welds, micro structural examinations and hardness asse...
Context in source publication
Context 1
... of each material, the sample measurements of one hundred seventy five mm x 25 mm x 1.5 mm were once organised due to tensile cut control in compliance with the AWS C1.1. The parameters old for dot welding are proven within ' Table 2'. The suture geometry because obtruncate power check is proven into configuration 1 because of warmth handled non-heat dealt with samples. ...Similar publications
Friction stir spot welding a relatively new solid-state joining technique usually used by automotive manufacturers as alternative to rivets and conventional spot welding resistance has led to the development of a fairly new technique a double-sided friction stir spot welding technique, this method was implemented for aluminum alloy AA6061-T6 by 2 m...
Aluminium alloys reveals good mechanical properties when soldered with Friction Stir welding. Thus to get these preferred mechanical properties, particular welding procedure parameters are to become examined. Nowadays aluminium alloys have actually been actually extensively used in industrial uses like aerospace and automobile as a result of their...
In this study, the strength prediction model for dissimilar joint between aluminum alloy (AA3003) and steel (GI DP780) in resistance spot welding (RSW) was proposed using response surface methodology (RSM). The welding was carried out using pedestal type with medium frequency DC electric power and hydraulic cylinder type spot welding machine. The w...
DP600 steel and AA7075-T6 aluminium alloy plates were joined using the friction stir spot welding process. The effects of different tool rotational speeds on the mechanical properties, intermetallic compound formation and interface microstructure of welded joints were investigated. The highest lap shear tensile load was obtained from the samples jo...
Aluminium alloy is widely used in engineering application, and it can be classified based on the constituent elements or alloying elements. Aluminium alloy is preferred for the nature of its tensile strength, ductility, and corrosion resistance in this research to make a dissimilar friction stir welding joint of aluminium alloys 7079 and 8050 mater...
