Table 1 - uploaded by Like Pan
Content may be subject to copyright.
Chemical composition of A356 (mass fraction, %)
Source publication
SiCp/A356 composites with high content of 40% (volume content) were prepared by vacuum semi-solid stirring method, and the derived composites with 10%, 20%, 30% (volume content) particle content were prepared by dilution method with 40% (volume content) composites. By comparing the derived materials prepared by dilution of high content composites w...
Similar publications
An investigation was carried out to find the effect of Al/Si content on mechanical properties in Zn-Al alloys. Six different alloy compositions were cast with Zn at 60 wt. % and Si varying from 0 wt. % to 5 wt. %. The alloys were prepared using stir casting process and poured into permanent mould metallic die. Micro-hardness, ultimate tensile stren...
Twelve new kinds of Al-Cu-Mg-Zn alloys with different components were designed on the basis of optimizing main alloying elements, including Zn, Mg and Cu to resolve hot crack problems of Al-Cu-Mg-Zn series alloys during liquid forging. Hot cracking susceptibility (HCS) was adopted to characterize hot cracking tendency, evaluated using constrained r...
The increase of B4C addition into an AA6061-B4C composite system will not be always an ideal choice for improved properties because of the issues related to incorporation, distribution, and interfacial wetting while stir-casting. In such a case, ultrasonication is considered to be an alternative to get the advantage of microstructural changes which...
Internal erosion refers to the movement of fine particles within soil framework due to subsurface water seepage. Existing criteria for assessing internal erosion usually are based on static loading, and the effect of cyclic load is not considered. Additionally, there are limited studies to examine the particle-size distribution and origin of eroded...
Samples of ductile iron alloyed with 0.88 % Ni with a nodule count of 606, 523, and 290 nod/mm2 were obtained from sand cast plates of different thickness in the range from 8.46 to 25.4 mm. The effect of the nodule count was evaluated during the austempering process held at 285?C and austempering times of 15, 30, 45, 60, 70, and 90 min. The volume...
