Table 2 - uploaded by Uğur Özdemir
Content may be subject to copyright.
Source publication
ASTM A743 CA6NM alloy is a martensitic stainless steel typically used in energy industry -runners and hydraulic turbine components- due to its superior toughness, yield and fatigue properties. In both the manufacturing, shielded metal arc welding is applied to join for this grade steels. However, weldability of the steels is limited due to formatio...
Similar publications
A welded steel protective cover used for the heat treatment of steel sheet coils is investigated. The protective cover is made of austenitic stainless steel and consists of three main segments, welded together, which have 1400 mm height each. The plate thicknesses at the lower, middle and upper segments are different. The investigation aimed to imp...
The applicability of ferritic stainless steel is restricted due to its low weldability, and this can be attributed to the severe grain growth in the weld zone during the solidification of the weld pool and formation of fully ferritic structure. This study aims to investigate the weldability of 18 mm thick AISI 409 ferritic stainless steel plates us...
This paper analyzes the corrosion resistance and the mechanical and microstructural properties of a welded joint of ductile cast iron using AISI316L stainless steel as filler material and three different heat treatments: preheating at 250 and 450 ºC and a post-weld annealing treatment. The results show the presence of ledeburite at the interface be...
Multi-material components, also known as functionally graded materials (FGMs), are innovative materials that possess unique properties due to their composition and have many potential applications in engineering and science. The effect of the heat treatment (HT) of functionally graded materials 15–5 precipitation-hardened (PH) martensitic steel and...
In a wind power plant of a wind power plant limited liability company, the fixed shaft of the torsion arm of the gear box broke during the operation of a wind power generator set. In order to find out the cause of fracture, the fracture fixed shaft of torsion arm was comprehensively detected and analyzed by means of appearance morphology analysis,...
