Table 2 - uploaded by Prashant Prabhakar Shah
Content may be subject to copyright.
Capacitor values (10 e-08) F for different collector currents by using five different defuzzification methods.
Source publication
Studies on RC snubber network design calculations for Half Bridge
Converter using Fuzzy Logic have been reported in this communication. It
confirms the applicability of the fuzzy logic to SMPS design. Fuzzy Logic is
an alternative design methodology simpler than conventional methods. The
use of fuzzy logic helps to circumvent the need of rigorous m...
Contexts in source publication
Context 1
... generates clipped fuzzy sets (CFS) representing values of appropriate R and C. The process of inference is shown in fig.4. Table 2 and Table 3. Table3: Resistor value Ω for different collector currents by using five different defuzzification methods. ...
Context 2
... 2 and Table 3. Table3: Resistor value Ω for different collector currents by using five different defuzzification methods. Table 2 gives snubber capacitor values (with multiplier of 10 e-08 F) for different collector currents by using five different defuzzification methods. Table 3 gives snubber resistor value for different collector currents by using five different defuzzification methods. ...
Similar publications
In this paper a new method for the parameterization of general type-2 fuzzy membership functions. The proposed method describes the methodology, equations and pseudo-code for building a set of general type-2 membership functions, which are a combination of two Gaussian-type primary membership functions (Gaussian with uncertain mean, and Gaussian wi...
Citations
This paper describes the exploring of fuzzy logic in wire manufacturing
process to determine the moisture free PVC temperature. Insulated wire
manufacturing process goes through number of phases before yielding a
desired quality of insulated wire. The first phase of wire manufacturing is the
controlling of PVC- temperature to make it free from the moisture. The idea of
adding the fuzzy logic in the decision of set temperature based on PVC-grade
is to implement Operator’s experience exercised in optimizing moisture free
temperature. Ambiguity involved in the operator’s setting is attempted to
model by developing a Fuzzy Inference Scheme (FIS). Simulation model
developed using Fuzzy Control block in MATLAB has been studied for
different types of Membership Functions (MF) and Defuzzification methods.
The fuzzy logical decisions found to be in good agreement with operators
manual settings after adequate tuning of FLC.
