Fig 4 - uploaded by Wenyao Zhai
Content may be subject to copyright.
Antenna lens layout with its SIW feeding network.

Antenna lens layout with its SIW feeding network.

Contexts in source publication

Context 1
... vias are used whenever SIW is bended to improve the return loss. The overall layout is shown in Figure 4. We take the advantage of the 'fat' beam in H-plane of the lens antenna to cover the Elevation plane. ...
Context 2
... lens antenna gains over frequency measurements are shown in Figure 8. The gain discrepancy over the ports is due to the unequal feed lines' length as well as the different number of SIW bends as shown in Figure 4. There is also finite coupling losses between adjacent SIW lines, we try to put include as much shield via as possible to minimize this loss. ...

Similar publications

Article
Full-text available
A microstrip-fed air-substrate-integrated waveguide (ASIW) slot array with high efficiency and low cost is presented. The design cuts out the substrate material within SIW, replaces the vias with metallic sidewalls, and uses a simple microstrip line-waveguide transition to feed the slot array. Radiating slots are cut on a 5-mil brass-plate, which c...
Article
Full-text available
This paper presents a high-performance fully metallic dual-polarized wideband Vivaldi array for the Ka band (26–40 GHz), which is going to be used, for example, in 5G millimeter wave (mmWave) communication networks. Antenna-array elements are fed straight from a single printed circuit board (PCB) that allows integrating active components in the imm...
Article
Full-text available
This paper presents a design procedure for a phased array feed network. The procedure is validated by designing and fabricating a set of 28 GHz 8-element beam steerable antennas. Within the feed, a Taylor n-bar amplitude taper is implemented using unequal power dividers. At boresight, the taper reduced the sidelobe level by 2.84 dB to -15.2 dB. Bea...

Citations

... However, this increases significantly the cost and the loss of the system. An alternative that permits to increase angular range consists in using beam switching antennas with Lüneberg lens, Rotman Lens or with other types of beam forming networks [2][3][4]. ...