Figure - uploaded by Claude Ziad El-Bayeh
Content may be subject to copyright.
![A table presents the Harmonic number for each sequence [16].](profile/Claude-El-Bayeh/publication/303634763/figure/tbl1/AS:613909115445278@1523378747300/A-table-presents-the-Harmonic-number-for-each-sequence-16.png)
Source publication
![A table presents the Harmonic number for each sequence [16].](profile/Claude-El-Bayeh/publication/303634763/figure/tbl1/AS:613909115445278@1523378747300/A-table-presents-the-Harmonic-number-for-each-sequence-16_Q320.jpg)
Harmonics in power systems are very dangerous and may cause different problems for equipment, i.e. the third harmonic has the same amplitude and angle in each phase of a three phase system. It enters into the neutral and may damage or overheat it if the system is unbalanced. The fifth harmonic causes an inverse polarity in machines where the magnet...
Contexts in source publication
Context 1
... such calculation can be found using specific software or a table similar to Table 1. But even, the software can be more simplified in order to reduce the time of simulation and the consuming time to develop such software. ...Context 2
... even, the software can be more simplified in order to reduce the time of simulation and the consuming time to develop such software. Table 1 can also be used to pick out the harmonic sequences, but the disadvantage of this table is that for high harmonics the table will be very large and not practical, and it needs to be always carried. ...Citations
The analysis of current and voltage sinusoidal wave analysis of AC power system is the key area of research in computational science. Unlike the previous decades, it is a field for preventive and corrective measures from the safety and performance point of view. Our team has analyzed the harmonics problem in residential areas extensively with a special emphasis on suddenly accepted methodologies and Fourier analysis and developed some techniques to troubleshoot the fluctuations in the electrical network harmonics. There are a few problems of harmonics in the electrical power systems and their critical analysis may help a lot in increasing the performance. We have reviewed certain possible topologies to cut down harmonics in the power systems and rectify to provide pure sinusoidal voltage and current for the better health and long life of expensive modern devices. New inventions in this direction are the need of the time, because the harmonics alter the facilities provided by electrical distribution systems for any kind of maintenance and troubleshooting
