Fig 1 - uploaded by Getachew Admassie Ambaye
Content may be subject to copyright.
Download
View publication
2D Model of spur gear [1].

2D Model of spur gear [1].

Source publication
Fig. 1. 2D Model of spur gear [1].
Fig. 2. Gear (a) radius of curvature and (b) velocities of gear.
Fig. 5. Maximum contact pressure.
Fig. 6. Lubrication regimes (a) HDL, (b) ML, (c) BL and (d) Solid-film...
+1 Both gear and pinion are made from steel SAE-AISI 1045 at 20 o C.
Determination of Important Contact Parameters for Spur Gear Design
Article
Full-text available
  • Oct 2021
This study focused on the determination of the important contact parameters of spur gear design for the investigation of different parametric studies such as the maximum pressure, contact width, contact film thickness, sliding velocities, and others. The single and double tooth contact region has been determined for the given gear parameters along...
Cite
Download full-text

Contexts in source publication

Context 1
... this section the length of mesh initiation and termination, contact ratio, surface and sliding velocity of the gear will be determined. Figure 1 shows the length of contact, recess and approach angles for a mesh. The length from point A to C and from C to E is called the length of mesh initiation (approach) and length of mesh termination (recess) respectively [1]. ...
Context 2
... Figure 1, it is shown that a single tooth contact is occurred between points B and D. This indicates that the single tooth contact starts at length AB (S1) and ends at length AD (S2) from mesh initiation (point A). The pitch point (C) can be taken as a reference and then the length along the right side of this can be considered as a positive and along the left side negative. ...