Figure 1 - uploaded by Bjarke Eltard Larsen
Content may be subject to copyright.
2.1: A sketch of the seepage flow. Figure taken from [Sumer 2014] 

2.1: A sketch of the seepage flow. Figure taken from [Sumer 2014] 

Source publication
Thesis
Full-text available
In this thesis the simulation of wave plus current induced scour beneath a pipeline is simulated using a fully coupled hydrodynamic and morphological model in the OpenFoam environment. The hydrodynamics are simulated by solving the incom-pressible Reynolds averaged Navier-Stokes equations with a k − ω turbulence model for closure. Simulations of 80...

Similar publications

Article
Full-text available
Wave forces on two side-by-side boxes in close proximity under wave actions were analyzed using the OpenFOAM package. The upstream box heaved freely under wave actions, whereas the downstream box remained fixed. For comparison, a configuration in which both boxes were fixed was also considered. The effects of the heave motion of the upstream box on...
Article
Full-text available
In this paper, we describe the method, which is the composition of finite volume method (FVM) and adaptive mesh refinement (AMR). We use it to solve car final drive inner volume oil lubrication problem. The computational algorithm is implemented using OpenFOAM parallel library that provides data structures and routines to work with the finite volum...
Article
Full-text available
The heat exchanger distributor, which connects the tube carrying the medium to the heat transfer geometry, has received less attention in research studies compared to heat transfer geometries. However, the flow distribution is critical to efficiency. Therefore, a model-in-the-loop approach is presented to optimize additively manufactured distributo...
Preprint
Full-text available
We explore the applicability of MATLAB for 3D computational fluid dynamics (CFD) of shear-driven indoor airflows. A new scale-resolving, large-eddy simulation (LES) solver titled DNSLABIB is proposed for MATLAB utilizing graphics processing units (GPUs). The solver is first validated against another CFD software (OpenFOAM). Next, we demonstrate the...
Preprint
Full-text available
The remoteness and extreme conditions of the Arctic make it a very difficult environment to investigate. In these regions, the wind has a substantial effect and redistributes a large part of the snow, which complicates precipitation estimates. Moreover, the snow mass balance in the sea ice system is still poorly understood, notably due to the compl...